Veneer hot press is a kind of hot press. I believe that through the related articles on the website and the related knowledge and learning, it is possible to let you gradually understand and understand the products of this website, and at the same time, have a good learning effect. In turn, the knowledge gained can be applied and used flexibly in practical work. Then, in order to achieve the above objectives, the following will continue the study of the veneer press, I hope that everyone can take it seriously.

1. How to avoid veneer blistering on veneer veneer or veneer veneer?

For veneer veneer or veneer veneer, if you want to avoid the problem of veneering, you should do the following: the surface of the board should be flat and not uneven; it should be suitable for the pressure and temperature of the hot press. If the parameters are not suitable, you should adjust them in time. In addition, the time after the glue is not too long, usually after three to five minutes after the glue is applied to the veneer, hot pressing operation is required.

2. Can the melamine veneer only be veneered?

From the professional point of view, the melamine veneer is not only a single veneer, but also a double veneer. Specifically, it depends on the actual situation and processing requirements, as well as the product use. Therefore, it is possible to use either a single veneer press or a double veneer press, whichever is a veneer press.

3. In the process of using the veneer hot press, how to avoid the problem of bursting? In addition, is it suitable to use heat transfer oil on the hot press?

Veneer hot press This hot press, which wants to avoid the problem of bursting during use, is to do the following work in order to control the moisture content of the plate, hot press Have the right pressure and temperature, and the equipment is used in the right environment.

A veneer hot press, which can use a medium of heat transfer oil, and can also have a good use effect. In the amount of heat transfer oil, it is necessary to take into account the volume of the hot press and the length of the pipe, because it is determined by them. In addition, in the use of heat transfer oil, it should be comprehensive and standardized, in order to ensure the use of the medium.